Rule Bilge Pump Panel Switch Model 49

Rule Bilge Switches are simple, classic-looking on/off switches with enamel-coated stainless steel finish. These switches are simple enough to screw onto a boat dash and then be wired up directly to the battery. The switch itself uses crimped spade type electrical connectors.TheRule Bilge Pump Switch Model 49 is the perfect pump switch for smaller boats that want a simple on/off system to run their boat’s bilge pump. The 2-way panel switch does not come with a fuse holder and therefore requires an inline fuse holder which can be purchased through Blue Sea (see related products).For 3 wire Auto Bilge Pumps, essentially pumps with integrated float or sensor swithes, choose one of our 3-Way Panel Swiches (On-Off-(On)).FeaturesSuits 12v – 24v power supplyTwo-Way Switch Panel: ‘On’ and ‘Off’Marine resistant stainless steel switches with enamel finishMeets safety need for bilge pumps to be independently switchedCome with 2 spade electrical connectors (1mm) and 2 attachment screws (5mm) included for installationWiring diagram and instructions includedSpecificationsDimensions: 57mm wide, 50mm highPower supply: 12-24v2 x screws required (5mm i.d)Max Amps (DC): 20 (12V), 10 (24V)Cable: 1mm tinned marine wireActual Weight: 0.06 KgInstructionsCut a minimum hole in the dash of 35mm x 24mmTake the 1mm electrical wire (sold separately) and strip the wire back 1/4″ before soldering and crimping on the spade connectionsThe negative wire should be connected directly to the negative terminal on the battery or suitable ground such as an engine blockWire an inline fuse into the wire leading to the positive terminal as per below