International Watertite Epoxy Filler

International Watertite is a quick-drying epoxy filler suitable for use on GRP, Metals and rigid Wood constructions. The formulation does not shrink and is extremely water-resistant, making it suitable for osmosis damage repairs.FeaturesFills up to 20 mm without saggingHigh-strength and adhesion properties, very fast drying and super smoothSimple 1:1 mixing ratio for easy measurement of the componentSpecificationsBrand: InternationalCapacity: 250ml & 1LArea: Above the Waterline & Below the WaterlineSuitable for Above the Waterline: Hull, Deck – smooth, Deck – non-skid, Bilge/Lockers, Exterior cabin/trims, Interior cabin/trimsSuitable for Below the Waterline: HullSubstrates: Aluminium / Zinc-Galvanised Steel, Cast Iron, GRP/FRP, Lead, Steel, WoodApplication Method: KnifeTypical Shelf Life: 2 YearsPreparationThe surface must be clean and dry. When treating osmosis, prime with Gelshield first. Otherwise, prime as below.Bare Grp: Gelshield 200 or VC Tar 2 for osmosis protection, or Primocon.Steel/Iron: Above water: Inter Protect or Yacht Primer. Below water: Inter Protect, or VC Tar 2, or Primocon.Aluminium: Above water: Inter Protect or Yacht Primer. Below water: Inter Protect, or VC Tar 2, or Primocon.Lead: VC Tar 2, or Inter protect or Primocon.Bare Wood: Above water: Yacht primer. Below water: Inter Protect or Primocon.MethodRemove any dust from the surface. Apply firmly in a spreading action. Fill to a level slightly above the surrounding area. When hardened, sand smooth with 80220 grade wet or dry paper. If left longer than 24 hours, two-component epoxy fillers will need sanding with 80220 grade wet or dry paper to ensure a good physical key.HintsMixing: Mix the two components thoroughly to an even colour. Mix both components together thoroughly to correct the mix ratio.Thinning: Do not thin.Cleaner: YTA061 International Epoxy Thinners 7.Ventilation and Humidity Control: Avoid cold, damp conditions, which may cause a stickiness to form on the surface. This should be removed by water and a 3M Scotchbrite pad or sanding.Other: Large areas should be sanded with paper on a board twice the length of the repair area. This will allow for the curvature of the hull. Small areas can be sanded using a sanding block. Sand as soon as possible after the sandable time, as Watertite continues to harden with time.Hazard WarningsHazard Pictogram :Signal Word:WarningHazard Statements:Causes serious eye irritationCauses skin irritationMay cause an allergic skin reactionToxic to aquatic life with long-lasting effectsPrecautionary Statement:General:Read the label before use. Keep out of reach of children. If medical advice is needed, have product container or label at hand.Prevention:Wear protective gloves. Wear eye or face protection. Avoid release to the environment.Response:IF ON SKIN: Take off contaminated clothing and wash it before reuse. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.Storage:Not applicable.Disposal:Dispose of contents and container in accordance with all local, regional, national and international regulations.Hazardous IngredientsPhenol, Polymer with Formaldehyde, Glycidyl Ether, Reaction Product: Bisphenol-A-(Epichlorhydrin); Epoxy Resin, Oxirane, Mono[(C10-16-alkyloxy)methyl] Derivs.Supplemental Label ElementsContains epoxy constituents. May produce an allergic reaction.Technical Files Part A – Safety Data Sheet Part B – Safety Data Sheet